GENERAL OPERATING INSTRUCTIONS
1. Slowly pull hose from reel to desired length. A ratcheting mechanism inside
reel makes a short series of clicking sounds every half revolution of reel.
2. To lock reel in position, listen for clicking sounds as hose is slowly pulled from
reel.When reel clicks,stop pulling hose. Decrease tension on hose and reel
should lock in position.
3. To retract hose onto reel, slowly pull out hose until series of clicking sounds
stops (1/8 revolution).
DO NOT LET GO OF HOSE! Allow hose to retract slowly until hose stopper rests
against hose guide.
4. Periodically check the hose for excessive wear and hose connections for air
leaks.
5. Attach a coupler (sold separately) to your air compressor hose and apply
thread seal tape to the Inlet fitting on the Reel. Connect the coupler to the Inlet
fitting.
6. Connect your air tool to the other end of the Hose using another coupler and
thread seal tape.
7. Follow all instructions from the air tool and compressor for set up and use.
8. When finished using the Hose, disconnect the air tool and retract the hose.
Wipe the Hose Reel clean with a dry cloth.
