7. MAINTENANCE
CLEANING, MAINTENANCE, AND LUBRICATION
1. BEFORE EACH USE, inspect the general condition of the tool. Check for:
•
loose hardware or housing,
•
misalignment or binding of moving parts,
•
cracked or broken parts, and any other condition that may affect its safe
operation.
2.AFTER EACH USE, re-wind the hose onto the reel and wipe the Hose Reel
clean with a dry cloth.
HOSE REPLACEMENT
1.Remove the Hose Stopper from the hose and set aside.
2.Pull out the old Hose and securely lock the Hose Reel.
3.Disconnect the old hose from the swivel joint and remove the hose.
4.Run the new hose through the Guide Roller and through the opening in the
drum flange.
5.Use thread seal tape on the hose fitting threads and screw the fitting onto the
swivel and tighten.
6.Attach the Hose Stopper on the end of the Hose near the Outlet fitting.
7.Carefully release the Drum Latch and allow the Hose to wind onto the reel,
evenly distributing the Hose across the Reel.
WARNING
•
To prevent serious injury
：
Detach air supply from this product before performing any inspection,
maintenance, or cleaning procedures.
•
To prevent serious injury from tool failure:
Do not use damaged equipment. If abnormal noise, vibration, or leaking air
occurs, have the problem corrected before further use.
NOTICE
•
These procedures are in addition to the regular checks and maintenance
explained as part of the regular operation of the Hose Reel.
WARNING
•
Internal spring is not user serviceable or user-replaceable.
