NEFF T28V56N0, Инструкция по эксплуатации, установке и уходу

Страница: 16 / 28

16
Converting the
burners to
another type of
gas (for the fitter)
Changing the
nozzles
Nozzles for conversion to LPG are provided with
this appliance or can be obtained from the after
sales service (see list included).
Prior to making the necessary adjustments, the
hob must be disconnected from the mains.
To see which gas type has been preset in the
factory; refer to the rating plate in this manual or on
the underside of the hob.
Picture 5
Picture 6
CHANGING THE NOZZLES
The burners are adaptable to different types of gas
by replacing only the nozzles for the type of gas
used (see data table). To access the nozzle, simply
remove the cap and flame-breaker.
To change the nozzles, use a no. 7 socket wrench
(picture 5).
REGULATION OF MINIMUM FROM LPG TO NG
Our taps are suitable for all types of gas and are
regulated at the minimum as follows:
1. Light the burner and turn the knob to the
minimum position. If the flame should go out,
proceed as follows:
a.) light the burner at maximum capacity (large
flame)
b.) remove the knob
c.) introduce a small screwdriver in hole B on
the shaft of the tap (picture 6) and unscrew
the adjustment screw by two turns.
d.) replace the knob and turn to the minimum
position (small flame)
2. Remove the knob from the tap
3. Introduce a small screwdriver in hole B
(picture 6) and tighten or loosen the adjustment
screw (taking care not to turn the shaft of the
tap) until the burner flame is properly adjusted at
the minimum.
Check that when passing quickly from the maximum
position to the minimum the flame does not go out.