NEFF C67P70N3GB, Инструкция по эксплуатации

Страница: 17 / 40

17
It is sufficient to clean the cooking compartment every two to
three months. If requiered, you can clean the oven more
frequently than this. Cleaning only requires approximately
3.8 kilowatt hours.
Setting pyrolytic cleaning
1.
Press the operating mode selector.
“Appliance is ready for use” appears on the text display.
2.
Turn the operating mode selector until the V Pyrolytic
cleaning appears on the text display.
3.
Start the cleaning operation with ƒ .
The oven door locks shortly after operation starts. “Door
locked” appears in the text display.
Once pyrolytic cleaning has finished
Cleaning has finished. The oven stops heating. “Appliance is
ready for use” appears on the text display.
Checking the cleaning time
Press the clock function button à twice. The remaining
cooking time without cooling down time is shown for a few
seconds.
Cancelling the setting
Switch off the appliance using the operating mode selector. If
the oven is already locked, you cannot open the oven door until
the “Door locked” display goes out.
Setting cleaning to run overnight
So that you can use your oven throughout the day, delay the
end of the cleaning process to during the night. See the section
Electronic clock, Setting a later end time .
After cleaning
Once the cooking compartment has cooled down, wipe out the
ash that has been left behind in the cooking compartment with
a damp cloth.
Care and cleaning
With careful care and cleaning your microwave oven will retain
its looks and remain good order. We will explain here how you
should care for and clean your appliance correctly.
:
Risk of electric shock!
Penetrating moisture may cause an electric shock. Do not use
any high-pressure cleaners or steam cleaners.
:
Risk of burns!
The appliance becomes very hot. Never touch the interior
surfaces of the cooking compartment or the heating elements.
Always allow the appliance to cool down. Keep children at a
safe distance.
Notes
■
Slight differences in colour on the front of the appliance are
caused by the use of different materials, such as glass,
plastic and metal.
■
Shadows on the door panel which look like streaks, are
caused by reflections made by the oven light.
■
Enamel is baked on at very high temperatures. This can
cause some slight colour variations. This is normal and does
not affect their function. The edges of thin trays cannot be
completely enamelled. As a result, these edges can be
rough. This will not impair the anti-corrosion protection.
■
Unpleasant odours, e.g. after fish has been prepared, can be
removed very easily. Add a few drops of lemon juice to a cup
of water. Place a spoon into the container as well, to prevent
delayed boiling. Heat the water for 1 to 2 minutes at
maximum microwave power.
Cleaning agents
To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
Do not use
■
sharp or abrasive cleaning agents,
■
metal or glass scrapers to clean the glass in the appliance
door,
■
metal or glass scrapers to clean the door seal,
■
hard scouring pads and sponges,
■
cleaning agents with high concentrations of alcohol.
Wash new sponge cloths thoroughly before use.
Cleaning the glass panels
The glass panels can be removed from the oven door for
cleaning.
:
Risk of burns!
The appliance becomes very hot. Never touch the interior
surfaces of the cooking compartment or the heating elements.
Area Cleaning agents
Appliance front Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Do not use glass cleaners or
metal or glass scrapers for cleaning.
Stainless steel Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Remove flecks of limescale,
grease, starch and albumin (e.g. egg
white) immediately. Corrosion can form
under such residues. Special stainless
steel cleaning agents can be obtained
from the after-sales service or from spe-
cialist shops.
Oven Hot soapy water or a vinegar solution:
Clean with a dish cloth and dry with a
soft cloth.
If oven is very dirty: use oven cleaner,
but only when oven is cold. It is best to
use a stainless-steel sponge.
Glass cover for the
oven light
Hot soapy water:
Clean with a dish cloth.
Control panel/outer
door panel
Glass cleaner:
Wipe dry immediately using a soft cloth.
Do not use a glass scraper.
Inner door glass Glass cleaner:
Wipe dry with a soft cloth. Do not use a
glass scraper.
Seal Hot soapy water:
Clean with a dish cloth, do not scour.
Do not use a metal or glass scraper for
cleaning.
Accessories Hot soapy water:
Soak and clean with a dish cloth or a
brush.