NEFF B45C42N0GB, Инструкция по эксплуатации

Страница: 32 / 36

32
Replacing the oven light bulb
Replace faulty oven light bulbs.
You can obtain replacement light bulbs from customer service
or specialist retailers: E14, 220 - 240 V, 40 W, heat resistant to
300 °C. Only use these oven light bulbs.
ã=
Risk of electric shock !
Disconnect the appliance from the power supply. Switch off the
circuit breaker or remove the fuse from the household fuse box.
1.
Place a tea towel in the cold cooking compartment to prevent
damage.
2.
Turn the glass cover anticlockwise and remove it.
3.
Replace the oven light bulb with a bulb of the same type.
4.
Screw on the glass cover again.
5.
Remove the tea towel and switch on the circuit breaker.
Note: If the glass cover cannot be unscrewed: use rubber
gloves to turn it. You can order a special removal tool through
the after-sales service (order no. 613634)
Changing the door seal
If the door seal is defective, it must be replaced. Replacement
seals for your appliance can be obtained from the after-sales
service.
Unhooking the door seal
The door seal is fixed in nine places.
1.
Unhook (Fig. B) the door seal at four points (Fig. A).
2.
Hook the door seal in at five further points (Fig. C) by turning
the hooks slightly (Fig. D).
Hooking in the door seal
1.
Hook (Fig. B) the door seal in at four points (Fig. A).
2.
Hook the door seal in at five further points (Fig. C) by turning
it slightly (Fig. D).
3.
Check that the door seal is seated correctly.
Cooked dishes turn out too moist or too
dry when cooking with steam-assisted
applications
The wrong altitude has been set Check the altitude in the Basic settings
menu and adjust if necessary
The wrong steam intensity was selected Select a higher or lower steam intensity
The appliance requires frequent descaling The water hardness has been set too high Check the water hardness in the Basic
settings menu and adjust if necessary
"E870" appears in the temperature display The pump has pumped air several times
in succession
Press the KJ clock function button.
Filling the water tank
"E8XX" appears in the temperature display The steam-assisted function is
malfunctioning
Press the
KJ
clock function button.
Note:
Applications without steam are
ready for operation
Problem Possible cause Remedial action
$ %
& '