Connection to an AV-receiver / home cinema
In case you have already connected your PC or game console with the AV-receiver of your home
®
cinema system, you can additionally connect the SeatQuake system.
However, there must be free „PRE-OUT“ outputs on your AV-receiver .
1)
Check your AV-receiver to see if any of these
connection possibilities are available:
Either an output for analogue recordings (e.g.
TAPE-OUT), a PRE-OUT for the front audio signal (e.g.
Front L / R) or a PRE-OUT to connect an additional
subwoofer.
2)
When any of the options listed above is available,
you will need an adapter cable that‘s long enough
to connect the AV-receiver to the SQ-AMP MK-II.
Stereo Cinch plug to 3.5mm auf 3,5mm stereo jack.
These cables are available in different lenghts at your
local electronics retailer.
3)
Connect the cable to one of the mentioned outputs
and to the 3.5mm stereo jack (green SIGNAL INPUT)
of the SQ-AMP MK-II.
Then follow the instructions 5) - 7) on
page 10
.
NOTE:
If necessary some additional settings of the AV-receiver must be activated to use all the
outputs. Please check the manual of your AV-receiver. When using the subwoofer PRE-OUT, the
separating frequency should be be adjusted as high as possible to leave more room for the frequency
control of the SQ-AMP MK-II.
Example: In this case the PRE-OUT‘s for the front channels or one of the
subwoofer outputs could be used for example.
PAGE 12
Hint
: In case your subwoofer output is already occupied by an existing subwoofer so there is no free connection left,
you can help yourself with a y-adaptor: It comes with a cinch plug and two cinch couplings. The subwoofer can now
®
be used together with the SeatQuake system.
