Nederman FlexPAK 800 DX, Руководство пользователя

Страница: 37 / 404

FlexPAK 800/1000 DX
35
EN
it is quicker and causes less spreading of dust. The work is easy, if the unit is placed so it
can be tilted, see Figure 15 . Also, the filter may be lifted straight up, see Figure 16, with a
crane or other lifting device.
If the filter bags are replaced separately, the plastic holders will also have to be replaced.
Figure
17 , items A–C, shows how the rubber sealing rings are to be fitted. When a used
sealing ring is to be re-used, the form when open may differ from the original form as
shown in item A. Use a screwdriver to bring the edge of the module between the rubber
lips to obtain the result shown in item C.
9.4 Change control filter
WARNING! Risk of personal injury.
• The vacuum and compressed air to the unit must be turned off before commencing filter
change.
• Use proper protective equipment.
NOTE! Always check main filter for damage when replacing the control filter.
The control filter should normally be replaced after 6000 hours of operation. The control
filter must also be replaced if damaged or if there is a high pressure drop over the
control filter.
Follow the procedure below:
1. Access the filter by removing the lid and side of the FlexPAK 800/1000 DX.
2. Disconnect the top piping of the filter housing and open top cover.
3. Remove and put the old filter in a large plastic bag, or wrap in plastic foil. Avoid dust
spreading.
4.
Fit a new filter cartridge in place. Ensure that the filter cartridge is centred and that
the rubber seal on the housing is intact.
5. Close the top cover and reconnect the pipes.
6. Check the earth connection between the control filter and GND1.
9.5 Spare parts
CAUTION! Risk of equipment damage.
Use only Nederman original spare parts and accessories.
Contact your nearest authorized distributor or Nederman for advice on technical service
or if you require help with spare parts. See also www.nederman.com.
Ordering spare parts
When ordering spare parts always state the following:
•
Part number and control number (see the product identification plate).
• Detail number and name of the spare part (see www.nederman.com).
• Quantity of the parts required.
9.6 Recycling
The product has been designed for component materials to be recycled. Its different
material types must be handled according to relevant local regulations. Contact the
distributor or Nederman if uncertainties arise when scrapping the product at the end of
its service life.