Nedap VP1103, Руководство по обслуживанию

Страница: 6 / 14

VP1103-200PM-00GB-Panel reader Manual version 1.1 / Page 3
2. Installing the VP1103 Panel reader
2.1. Mounting the VP1103 Panel reader
Installation and service should be done only by trained personnel. Always turn off the main
power when working on the de electrical installation. Keep animals away from the antenna
during installation and service. Close all covers when ready with installation or service.
See Appendix A for technical specifications before mounting. See Appendix B for corridor
requirements.
Mount the Panel reader unit firmly on a wall or at a (non metal) frame.
Mounting requirements:
1. The Panel reader must not be mounted close to any iron. This will influence the
performance of the antenna.
2. The Panel reader must not be mounted close to electrical equipment with
background noise. This can disturb the antenna.
3. The Panel reader must be mounted on a wall close to a stable power supply.
4. The Panel reader must be mounted > 1.5 m. from electrical cables or power supply.
5. The Panel reader may not be exposed to direct sunlight.
Example mounting
positions
Drill zone at least 4 cm
from the sides
Figure 3. Mounting positions on rear view VP1103 Panel reader
Mount the Panel reader in 4 positions with screws, bolts, and plugs etc. suitable to support the
Panel reader. Use a large washer behind the bolt/screw to give extra support. Use a screw or
washer with a minimum head diameter of 18 mm. The size of the holes in the antenna must be
corresponding with the size of the bolts or screws that are used.
Don’t damage the antenna when drilling holes for mounting the Panel reader. This
could damage the electronics and affect the functioning of the Panel reader. Keep a
minimum drill distance of 4 cm from the sides.
Install cables and power supplies / transformers > 1.5 m. from the Panel reader if
possible.