Nedap PowerRouter PR50SB-PR/S24, Руководство по установке

Страница: 28 / 52

4 Installation PowerRouter • Back-up / Stand-alone • Installation Manual
26
EN
4.11 Connect the additional cable (Italy)
The additional cable is only applicable for Italy (directive CEI-021). See figure 16 for the connection
overview.
1. Remove the plate from the knock-out hole (1).
2. Place the cable gland (4) from the bottom through the hole.
3. Fasten the cable gland with the nut (3) on the inside of the PowerRouter.
4. Slide the cable through the cable gland.
5. Connect the cable to the connector (2).
6. Fasten the cable-nut (5).
7. The cable can be connected to an external receiver from the power company. In figure 16;
Contact closure A (blue) activates the remote trip.
Contact closure B (green) activates the move frequency band signal.
C (orange) and D (brown) are not connected, for further use.
8. Install the clip-on coil (6) on the cable within 10 cm of the powerrouter.
4.12 Switch on the system
1. Close the lower front cover.
2. For 24V lead-acid batteries set the external battery disconnect switch to on.
3. Set the solar switch, on the PowerRouter, to on.
4. Set the external AC disconnect switch to on.
5. Switch on the PowerRouter (switch on the display).
4.13 Initialise the PowerRouter
The PowerRouter must be initialised by setting system parameters. After setting the parameters, the
PowerRouter is ready to use. There are two methods to set the system parameters.
4.13.1 Installation wizard (on the display)
1. The installation wizard starts automatically the first time you switch on the PowerRouter.
2. Use the buttons on the PowerRouter display to go through the installation wizard screens and make
changes.
CAUTION
The installation wizard only asks for basic battery settings, based on these settings the PowerRouter
updates other battery settings overwriting any customized battery settings. Any customized battery
settings will be lost.
i
If you start the installation wizard manually, you must enter a password. The password is the last four digits
of the serial number on the type plate at the bottom of the PowerRouter.