Necchi NC-204D, Инструкция по эксплуатации, Страница: 62 / 92

54
Use the seam ripper to cut the center of
the buttonhole being careful not to cut any
stitches on either side. Use a pin as a stopper
at the bar tack so you do not cut too much.
Note
When cutting the buttonhole with the seam
ripper, do not place your hands in the
cutting direction, otherwise injuries may
result.
Slightly hold the end of the upper thread and
start sewing. Pull two lines together.
Note
Gently feed the fabric by hand.
Before stopping, the machine will
automatically sew a reinforcement stitch
after the buttonhole is sewn.
When you finish sewing, raise the presser
foot lifter and cut the thread. To sew over the
same buttonhole, raise the presser foot lifter.
Position the fabric under the presser foot so
that the centerline’s mark is aligning with the
center of the buttonhole foot.
①
Starting point
Select the buttonhole stitch. Adjust the stitch
width and the stitch length to the desired
width and density.
1