Necchi K408A, Инструкция по эксплуатации

Страница: 45 / 60

39
v
Preparation for embroidering
and monogramming
* Embroidery hoop is not included with the
machine.
Install the darning plate.
Free motion darning, embroidery and
monogramming
Remove the presser foot and the presser foot
holder.
Draw the desired lettering or design on the
surface of the fabric.
Stretch the fabric between the embroidery
hoop as firmly as possible.
Place the fabric under the needle. Make sure
the presser foot bar is down to its lowest
position.
Turn the handwheel towards you to bring up
the bobbin thread through the fabric. Sew a
few securing stitches at the starting point.
Hold the hoop with thumb and forefinger of
both hands while pressing the material with
the middle and third finger and supporting the
outside of the hoop with your small finger.
n
Attention
Keep fingers away from moving parts,
especially needles.
Note
When you finish the work, move the
darning plate.
3.5