NEC XN120 Vision, Руководство пользователя

Страница: 15 / 34

Configure SIP Trunks
XN120 Voice Over IP Card Guide 15
Enter XN120 Configuration Mode.
(Refer to XN120 Configuration Mode at the end of this guide if you are not familiar with the XN120 system).
1 Program 10-03-01
You will need to change this
setting to match the network
setting.
Default Setting:
All VOIPU circuits are set to mode 0 (not used).
Ø Select the correct slot number with the Vol.
p q
keys.
You will see the trunk port number of Circuit 1 of the VOIPU card.
Ø
Press HOLD to confirm the entry and step to the next option.
You will see that the Type for this VOIPU trunk is set to 0. (0 will be
flashing).
Ø
Press 1 to change the mode to SIP
Ø
Press HOLD to confirm the entry and step to the next VOIPU
trunk.
Ø
Repeat this procedure until all VOIPU trunks are set to 1.
Ø Press DC several times when you are done to return to the
Program Mode.
(Press SPK to save changes and exit if you are finished).
2
Program 10-28-01
Domain Name. This setting is
the name of the SIP domain.
The value of this field does not
have to be a valid domain
name, but it is recommended
that the same domain name is
used for all XN120 systems
within the SIP network.
(example:
mysipnetwork.co.uk)
Host Name. This identifies
this particular XN120 system
within the SIP network.
(example: London)
UserID. This is the ID that is
sent when an outgoing call is
made (see Section 13).
Default Setting:
The Domain Name, Host Name and UserID items are blank.
Ø
Enter the domain name using the alpha-numeric keys. If you
make a mistake, press the DND/CONF key to erase the last
character.
Ø
Press HOLD when finished
Ø
Enter the host name using the alpha-numeric keys. If you
make a mistake, press the DND/CONF key to erase the last
character.
Ø
Press HOLD twice when finished
Ø Enter the UserID using the alpha-numeric keys. If you make a
mistake, press the DND/CONF key to erase the last character.
10-03-01 SlotNo 1
HBI01 Type 1
Press Vol p q
to select the
slot number
10-03-01 SlotNo 5
VOIPU 1 Port 4
Press Vol
p q
to select the
slot number
Press FLASH to
move the curser to
the circuit number
10-03-02 SlotNo 5
VOIPU 1 Type 0
The first trunk port
of the circuit will
be shown
10-28-01
Domain_
10-28-02
Host_
10-28-04
UserID_