Setting Up and Using the Software 3-3
6.
Type
a:winstall
and press
Enter
or click “OK.”
7.
Respond to the utility prompts as follows:
After reading the message that introduces the Medi-
aDock 2000 Setup Utility, click “OK” or press
Enter
to continue with the setup.
Specify the disk drive on which to install the
software. Press
Enter
or click “OK” to accept the
default drive c:.
Specify the subdirectory in which to install the
software. Press
Enter
or click “OK” to accept the
default subdirectory “MD2000.”
Wait while the utility copies the required software
into the specified subdirectory.
Read the screen that lets you know about changes
made to the AUTOEXEC.BAT and CONFIG.SYS
files. Click “OK.”
8.
Proceed as follows to load the audio drivers:
At the prompt, remove the setup utility diskette.
Insert the MediaDock 2000 Audio Applications
diskette 1 into the diskette drive, and press
En-
ter
.
The first audio screen tells you to close any ap-
plications that are running. If you followed the
instructions given here, you already closed open
applications. Just click “Continue” to proceed.
If you did not follow these instructions, click
“Exit.” Go back to the beginning of this section,
“MediaDock 2000 Setup Utility,” and start over.
