NEC UNIVERGE SL2100, Сетевое руководство

Страница: 153 / 196

Program
Number
Program Name Description/Comments Assigned Data 1 2 3
10-37-01 UPnP Setup – UPnP
Mode Default Gateway (WAN),
PRG 10-12-07 can be set
automatically when this pro-
gram is set to 1 = Enable. 0 = No (Disable)
1 = Yes (Enable)
default is 0 X
10-58-01 Network Address –
Network Address If there are other networks
connected to this system
that are not to be routed
through NAPT translations,
then these networks must
be identified in PRG 10-58.
Use this PRG to assign the
individual IP Address (e.g.
192.168.1.100) or assign the
whole network address (e.g.
192.168.1.0). Assign a valid IP Address or as-
sign a valid Network Address.
default is 0.0.0.0 X
10-58-02 Network Address –
Subnet Mask If there are other networks
connected to system that
are not to be routed through
NAPT translations, then
these networks must be
identified in PRG 10-58. Use
this PRG to assign the sub-
net mask for the IP Address
entered in PRG 10-58-01. Assign a valid subnet mask. de-
fault is 0.0.0.0 X
15-05-16 IP Telephone Terminal
Basic Data Setup –
Password Assign the authentication
password for SIP single line
telephones. Up to 24 characters
Default not assigned X
15-05-45 IP Telephone Terminal
Basic Data Setup-
NAT Plug & Play Per IP Single line telephone,
enable NAT Plug and Play
so that port forwarding is
NOT required in the router
the IP single line telephone
resides behind. Effective on-
ly when PRG 10-46-14 is set
to 1 = Enable. 0 = No (Disable)
1 = Yes (Enable)
default is 1 X
15-05-47 IP Telephone Terminal
Basic Data Setup –
Registration Expire
Timer for NAT On a per station basis, this
setting defines the SIP reg-
istration expiry timer. If this
value is set to 0, for the ter-
minal, the value in PRG
84-23-01 is applied. 0 = User Timer in Program
84-23-01 60~65535(sec)
default is 180 seconds X
15-05-48 IP Telephone Terminal
Basic Data Setup –
Subscribe Expire Tim-
er for NAT On a per station basis, this
setting defines the SIP sub-
scribe expiry timer. If this
value is set to 0, for the ter-
minal, the value in PRG
84-23-02 is applied. 0 = User Timer in Program
84-23-01 60~65535(sec)
default is 180 seconds X
84-26-01 VoIPDB Basic Setup
– IP Address Assign the IP Address for
each DSP resource on the
VoIPDB xxx.xxx.xxx.xxx
Default:
Slot 1 = 172.16.0.20 X
84-26-02 VoIPDB Basic Setup
– RTP Port Number Assign the RTP Port Num-
ber. 0~65534
Default for DSP1 is 10020 X
84-26-03 VoIPDB Basic Setup
– RTCP Port Number Assign the RTCP Port Num-
ber. 0~65535
Default for DSP1 is
10020~10083 X
ISSUE 1.0 SL2100
Networking Manual 10-9