NEC SuperScript 4400, Руководство пользователя

Страница: 36 / 143

28 SuperScript 4400 Series — User’s Guide
First, Prepare the Printer
1. Turn off the printer, remove the power cord from the rear
panel of the printer, and disconnect the printer cable
from the port
(A) . Position the printer so you are facing
the side and back corner where the cable port is located.
Make sure that you have enough room to work.
2. Using a small phillips-head screw driver remove the two
screws from the Interface Panel (expansion slot) on the
rear of the printer
(B) , and pull out the Controller Board.
3. Remove the screw that holds the small 1.5” x 3.75” plate
over the Network Slot. Remove the plate. Keep the screw
(C) .
Second, Install the NIC
These steps are illustrated on the opposite page.
4.
Remove the mounting screws and small bracket from the
end of the standoff pins on the Controller Board
(D) .
Avoid touching the Controller Board circuitry and
components!
5. Remove the NIC from its protective bag (E) . Handle the
NIC only by its edges.
6. Hold the NIC so that its circuitry faces inside the printer
and its LED’s face the back of the printer. Carefully align
the standoff pin with the lower right corner of the NIC.
7. Plug the NIC’s connector to the Controller Board as
shown
(F) .
8. Use the mounting screws and bracket (removed in step 4)
to fasten the NIC to the standoff pins as shown. Attach
the screw removed from the front in step 3
(G) .
9. Slide the Controller Board back in the expansion slot.
Reinstall and tighten the screws
(H) .
Network Slot
A
B
C
Preparing the Printer