NEC S2900, Руководство пользователя

Страница: 103 / 168

86
After the disk drive is securely seated, push down the ejector that was opened upward until
the lever clicks indicating the installation is complete.
When inserting the disk drive into the disk enclosure, push it as far as it will go and then
lock the ejector.
Incorrect insertion may cause a malfunction.
5.
Inserting a new disk drive allows the data recovery to be started automatically.
„ If the Auto Repair feature is set to OFF, issue a recovery instruction from the
management software in manual mode to start data recovery. Otherwise, the reduced
state ("reduce" shown as the logical disk status) remains.
„ Setting the Auto Repair feature to ON in while in the recovery wait state will not start
the data recovery. The setting is enabled starting with the next recovery.
6.
The FC/SATA disk enclosure and the disk array unit operate normally during the data
recovery. At the termination of the data recovery, the SERVICE LEDs on the array
controller and FC/SATA disk enclosure go off.