NEC POWERMATE P2166, Руководство пользователя

Страница: 156 / 221

Setting System Board Jumpers 5-7
12.
Replace the system unit cover. Reconnect the system
power cables and peripheral devices.
13. Power on the system.
14.
Run Setup (see Chapter 4, Setting System Parameters).
CLEARING CMOS
If you want to return your system to the factory default
settings, use the following procedure to clear CMOS to the
default factory settings.
!
CAUTION:
Clearing CMOS changes your setup configuration
including hard disk settings.
1. Power off the system and unplug any peripherals.
!
WARNING
The system power must be off before removing the
cover and changing a jumper setting.
2. Remove the system unit cover (see “Replacing the
Desktop Cover” or “Replacing the Minitower Cover”
in Chapter 3).
3.
Locate the CMOS Clear jumper J1K2 on the system
board (see the figure “Locating system configuration
jumpers”).
You may have to remove any installed expansion
boards to access the jumpers (see “Removing
Expansion Boards” in Chapter 3).