NEC PowerMate CT, Инструкция по обслуживанию и справочник

Страница: 79 / 167

Disassembly and Reassembly 3-21
Storing an Unused Rail
A – Front of Chassis C – Tab at End of Rail
B – Device Rail
2.
Press the rail against the wall of the bay with your thumb and press the tab toward the center
of the bay with your forefinger.
3.
Still pressing the tab, slide the rail into the bay along the guides until its tab clicks in place.
4. Place a bay cover over the empty bay (see “Replacing a Bay Cover”).
To retrieve a rail from an empty bay:
1. Press the rail against the wall of the bay with your thumb while you press the tab toward the
center of the bay with your forefinger.
2. When the tab releases, slide the rail out along the guide.
Removing or Installing Device Rails
The 5 1/4-inch bays are designed for use with devices that have tabbed rails. These rails allow a
device to be easily inserted and removed from the system. If you remove a device from the
system, always save the rails, right in the bay if it is empty, to use on a replacement device.
1.
Remove a rail by removing the two or three screws that secure it to the side of the device.
2. Secure each rail to the new device with the screws (two or three to a side) from the old
device.
Locating the Screws for 5 1/4-Inch Device Rails
A – Screw or Locking Pin B – Device Rail