NEC POWERMATE 2000 - S 02-2000, Руководство по выпуску

Страница: 5 / 10

NEC PowerMate 2000 Series Release Notes 5
If the PartitionMagic setup program asks you for a serial number, enter the following number:
PM400ENOEMCD-673785
See the documentation in the Userinfo folder for information about using PartitionMagic,
BootMagic™, and the recovery diskette program. Reading the Userinfo files requires Adobe
®
Acrobat
®
Reader. Adobe Acrobat Reader comes on the NEC Application and Driver CD.
Note
If you are installing BootMagic in a system with the Windows NT operating system, see
the next section, “Installing BootMagic in a System with Windows NT.”
Installing BootMagic in a System with Windows NT
BootMagic™ is a utility included in the PowerQuest PartitionMagic™ software. See the
previous section, “Installing PartitionMagic,” for general installation information.
If you have a Windows NT operating system, use the information in the following section to
correctly configure BootMagic.
If you already installed BootMagic and the configuration resulted in an error message, see
“Correcting the BootMagic Configuration.”
Configuring BootMagic
If you have a system with the Windows NT operating system, use the following procedure to
correctly configure BootMagic.
1.
Follow the instructions in the PartitionMagic Userinfo folder to install BootMagic. When
the “BootMagic Configuration” box appears at the end of the installation, continue to the
next step.
2.
Configure BootMagic.
„ If you want to use BootMagic:
Click the
ENABLE BOOTMAGIC
button. The BootMagic menu appears during the next
bootup sequence and lets you select Windows NT as the operating system.
„ If you do not want to use BootMagic:
Do not select the
ENABLE BOOTMAGIC
button. The BootMagic menu does not appear
at bootup.
3. Select SAVE/EXIT in the BootMagic Configuration box to complete the configuration
process. Either choice, to enable BootMagic or to not enable BootMagic, requires the
SAVE/EXIT selection.
To correctly complete the BootMagic configuration, you must select
SAVE/EXIT from the BootMagic Configuration box, even if you do not want to use BootMagic.
Omitting this step results in an error message.