10
1. Introduction
Battery Installation
NOTE: Actual operating range may differ slightly from that shown in the drawing.
TIP: You can determine which remote sensor on the projector is enabled in wireless mode. The options are: [FRONT/BACK],
[FRONT], or [BACK]. (
→
• The infrared signal operates by line-of-sight up to a distance of about 22 feet/7 m and within a 60-degree angle
of the remote sensor on the projector cabinet.
• The projector will not respond if there are objects between the remote control and the sensor, or if strong light
falls on the sensor.
Weak batteries will also prevent the remote control from properly operating the projector.
Operating Range for Wireless Remote Control
30°
30°
30°
30°
30°
30°
30°
30°
Remote sensor on projector cabinet
Remote control
Remote control
7 m/22 feet
7 m/22 feet
7 m/22 feet
7 m/22 feet
OP
EN
1
Press firmly and slide the battery
cover off.
2
Install new batteries (AAA). En-
sure that you have the batteries’
polarity (+/−) aligned correctly.
OP
EN
3
Slip the cover back over the bat-
teries until it snaps into place. Do
not mix different types of batter-
ies or new and old batteries.
