NEC NP-PA550W, Руководство пользователя

Страница: 157 / 235

145
6. Installation and Connections
Cautions when connecting an HDMI cable
• Use a certified High Speed HDMI
®
Cable or High Speed HDMI
®
Cable with Ethernet.
Cautions when connecting a DisplayPort cable
• Use a certified DisplayPort cable.
• Depending on the computer, some time may be required until the image is displayed.
• Some DisplayPort cables (commercially available) have locks.
• To disconnect the cable, press the button on the top of the cable’s connector, then pull the cable out.
• No power is supplied from the DisplayPort input connector to the connected device.
• When signals from a device that uses a signal converter adapter are connected to the DisplayPort input connector,
in some cases the image may not be displayed.
• When the HDMI output of a computer is connected to the DisplayPort input connector, use a converter (commercially
available).
Cautions when using a DVI signal
• When the computer has a DVI output connector, use a commercially available converter cable to connect the
computer to the projector’s HDMI input connector (only digital video signals can be input). Also, connect the
computer’s audio output to the projector’s Computer 2 audio input connector. In this case, switch the HDMI setting
at on-screen menu’s audio selection on the projector to [COMPUTER2]. (
→
page 109 )
To connect the computer’s DVI output connector to the projector’s DisplayPort input connector, use a commercially
available converter.
NOTE: When Viewing a DVI Digital Signal
• Use a DVI-to-HDMI cable compliant with DDWG (Digital Display Working Group) DVI (Digital Visual Interface) revision 1.0 stan-
dard. The cable should be within 197"/5 m long.
• Turn off the projector and the PC before connecting the DVI-to-HDMI cable.
• To project a DVI digital signal: Connect the cables, turn the projector on, then select the HDMI input. Finally, turn on your PC.
Failure to do so may not activate the digital output of the graphics card resulting in no picture being displayed. Should this happen,
restart your PC.
• Some graphics cards have both analog RGB (15-pin D-Sub) and DVI (or DFP) outputs. Use of the 15-pin D-Sub connector may
result in no picture being displayed from the digital output of the graphics card.
• Do not disconnect the DVI-to-HDMI cable while the projector is running. If the signal cable has been disconnected and then
reconnected, an image may not be correctly displayed. Should this happen, restart your PC.