NEC Nighthawk XT4100, Руководство пользователя

Страница: 11 / 54

E – 4
Terminal Panel
INPUT3
RGB R/Cr
G/Y
B/Cb
H/HV
V
R/Cr Cr
Y G/Y
B/Cb Cb
H/HV
V
OPTION
IN
OUT
REMOTE1
REMOTE2
INPUT7 INPUT8
INPUT5
S-VIDEO1
Y
C
S-VIDEO2
VIDEO1 VIDEO2
INPUT6
IN
OUT
INPUT2 INPUT1 INPUT4
5 6
1
2
3
4
9 10
8
7
1. INPUT 3 RGB Connector (Mini D-Sub 15 pin)
Connect your PC or other analog RGB equipment such as a high-defi-
nition document camera.
2. Option Connector (Mini D-Sub 9 pin)
For system expansion such as PC-control.
IN ................. connect to the external equipment such as PC.
OUT ............. for daisy-chaining multiple projectors and operating them with
the same external equipment. To do so, connect to a second
projector's IN terminal to relay the input at the IN terminal of
the first projector until all the projectors are connected.
3. REMOTE 1 Connector (Mini D-Sub 15 pin)
This terminal allows external control of the projector from either the
Switcher or from an external control. When the Switcher is used, con-
nect to the REMOTE 1 terminal on the back of the Switcher.
NOTE: This projector is compatible with the ISS-6020 Switcher.
4. REMOTE 2 Jacks
IN ................. wired remote control input.
OUT ............. for daisy-chaining multiple projectors and operating them with
the same remote control. To do so, connect to a second pro-
jector' s IN terminal to relay the input at the IN terminal of the
first projector until all the projectors are connected.
5. INPUT 1 and INPUT 2 Terminals (BNC)
Connect R,G,B,H (Horizontal sync) and V (Vertical sync) outputs of the
external equipment such as the Switcher. If using a component with a
combined sync (SYNC) output, connect it to the H/V terminal.
Also connect component video outputs (Y/Cb/Cr) of the external equip-
ment such as DVD player.
NOTE: The INPUT 2 terminal does not support SW1 Level and SW2 Level modes
for the ISS-6020 switcher.
6. INPUT 4 Cr/Y/Cb Terminal (RCA)
Connect component video outputs (Y,Cb,Cr / Y,Pb,Pr) of the external
equipment such as DVD player.
NOTE: This terminal accepts component signal only.
7. INPUT 5 VIDEO 1 Terminal (BNC)
Connect to the BNC video output of the external equipment such as a
VCR or laser disk player.
8. INPUT 6 VIDEO 2 Terminal (RCA)
Connect to the RCA video output of the external equipment such as a
VCR or laser disk player.
9. INPUT 7 S-VIDEO 1 Terminal (BNC)
Connect to the Y/C separate BNC video outputs of the external equip-
ment such as a VCR or laser disk player.
10. INPUT 8 S-VIDEO 2 Terminal (Mini DIN 4 pin)
Connect to the S-video output of the external equipment such as a
VCR with an S-video output. This terminal allows switching between S2
and S1 VIDEO input modes. See the "S-Video Mode Select" section on
page E-36 for more information.