![background image](http://html.mh-extra.com/html/nec/neccare-platinum-express5800-a1160/neccare-platinum-express5800-a1160_configuration-manual_251385066.webp)
Sending a
System Remote Monitoring Test Packet
8-2
2. On
the
Tools
menu, point to
Autodiscover
, point to
Foreground
, and then click
TCP/IP Hosts
.
The
Autodiscover (TCP/IP Hosts)
dialog box appears.
3. Click an entry under the
Map
heading, and then click
Address
.
The
Address
dialog box appears.
4. Ensure
that
Address and Mask
is selected.
5. Type the IP address for your network in the
Network Address
box, and type the
mask address for your network in the
Network Mask
box.
6. Click
OK
.
7. Ensure that the SNMP read-only community string is the same as the SNMP
read-only community string you configured for other components in your
environment.
8. Click
Start
.
The autodiscover utility discovers the servers on the specified network and populates
the right pane of the Operation Window with those servers. This activity might take some
time to complete.
8.3. Sending a System Remote Monitoring Test Packet
After a new system installation, sending a Remote Monitoring test packet ensures that
the Remote Monitoring communication is working. This test verifies that event
notification, Remote Monitoring packet generation, and packet delivery to the Support
Center is operational.
For Express5800/A1160 systems, this verification is not conducted through an
automated test. Instead, a manual procedure must be performed to generate an actual
fault so that a Remote Monitoring packet is delivered to the Support Center. NEC
interprets receipt of this initial Remote Monitoring packet as a Remote Monitoring test
notification. The fault you are inducing in the following procedure is an intentional loss of
AC power.
To perform this manual procedure, the system and system environment must meet
specific conditions:
•
The system must have AC redundancy.
•
Both cell power supplies must be fully operational at the time that the fault is
initiated.
•
The partition or partitions must be installed, configured, operational, and in a
running state.
•
The management server must be running and operational, with the Remote
Содержание NECCare Platinum Express5800/A1160
