NEC N600i, Руководство пользователя

Страница: 21 / 80

13
Introduction
Low Battery Alarm
The battery power has 4 levels and is indicated by the
following icons,
When the battery power becomes lower, the battery level 1
icon (red) appears. After a while a beep sound also warns
you.
When the battery runs out, the above image appears and
blinks. There also sounds an audible alarm. The phone
switches off automatically afterwards. If the low battery
alarm occurs during a call, the call will be disconnected
after approximately 60 seconds.
The volume level of the low battery alarm depends on the
settings of the ringtone volume on standby and the earpiece
volume during a call.
Switching your N600i on and off
To Switch On
After inserting the USIM card (see page 9 ) and the
inserting/charging the battery (see page 11 ), press the
key until the phone switches on (approximately two
seconds).
To Switch Off
In Standby mode, press and hold the key until the phone
powers down. There may be some delay while the phone
switches off. Do not attempt to switch the phone on again
during this time.
Power Saver
The power saver function turns the screen off when the
phone is left idle for a certain period of time. You can turn
the screen back on by pressing any key.
Setting the Clock
When using your N600i for the first time you are prompted
to set the current date and time.
To Set the Clock
☛
Press the MENU key, select the Settings icon, select
Date and time and Set date and time.
☛
Enter the current date and time. Refer to Date and
time on
page 53 for details.
Entering your PIN Code
If you want to secure information in your phone, you can
activate your PIN code so that the phone cannot be used
without entering the PIN as you switch on your phone. (For
information about how to activate PIN codes, refer to
Security on
page 54 .)
2
PIN1 and PIN2 numbers are usually supplied with your
USIM card. If not, or you have lost them, contact your
local representatives.
To Enter your PIN Code
☛
Ensure that your USIM card is in your N600i and that
the battery is charged.
☛
Press and hold the key until power is on.
☛
If the Password screen is displayed, enter your PIN1.
The code you enter appears as asterisks (*).
2
If you make a mistake while entering your PIN, delete the
wrong number by pressing the
key.
☛
Press the SK1 ( OK ).
If you are connecting onto another network, the name
of another operator appears.
Battery
level 2 Battery
level 3 Battery
level full Battery
level 1