English-12
Figure S.1
Flexible Arm Installation
This LCD monitor is designed for use with a flexible arm. Contact NEC for more information.
To prepare the monitor for alternate mounting purposes:
• Follow the instructions provided by the manufacturer of the display mount.
CAUTION:
To meet the safety requirements, the monitor must be mounted to an arm that supports the weight of the monitor.
See
page 28
for details. Remove the monitor stand before mounting.
Remove the Monitor Stand for Mounting
To prepare the monitor for alternate mounting purposes:
1. Disconnect all cables.
2. Place your hands on each side of the monitor and lift up to the highest position.
3. Place the monitor face down on a non-abrasive surface (
Figure S.1
).
4. Place one hand around the base and one hand on the Quick Release Lever.
Push and hold the Quick Release Lever in the direction indicated by the
arrows (
Figure S.1
).
5. Lift up the stand to unhook it from the monitor (
Figure S.1
).
The monitor can now be mounted using an alternate method.
Reverse the process to reattach stand.
NOTE:
Handle with care when removing the monitor stand.
Mount the Flexible arm
This LCD monitor is designed for use with a flexible arm.
1. Follow the instructions on how
Remove the Monitor Stand for Mounting
to remove the stand.
2. Use the attached 4 screws to fasten the arm to the monitor (
Figure F.1
).
Figure F.1
100 mm
100 mm
Weight of LCD assembly: 6.9 kg
CAUTION:
• Only use the screws (4 pcs) that are included or M4 sized screws
(Length: thickness of bracket and 10-12 mm) when mounting to
avoid damage to the monitor and stand.
• To fulfill the safety requirements, the monitor must be mounted to an arm
which, guaranties the necessary stability under consideration for the weight
of the monitor. The LCD monitor should only be used with an approved arm
(e.g. TUEV GS mark).
• Tighten all screws (recommended Fasten Force: 98 - 137N•cm).
A loose screw may cause the monitor to fall off the arm.
• Attaching the flexible arm should be done by two or more people if the monitor cannot be placed face down
on a flat surface for installation.
Mounting
Bracket
Screw
Washer
Unit
10-12 mm
Thickness
of bracket
and washer