Connecting Your PC Or Macintosh
Computer
Connecting your PC or Macintosh computer to your MultiSync
MT830 (SVGA) /1030 (XGA) Projector will enable you to project
your computer's screen image for an impressive presentation. All of
these following display standards are supported:
To connect to a PC, Macintosh or computer equipped with an XGA/
SVGA /VGA adapter or compatible graphics adapter, simply:
1. Turn off the power to your projector and computer.
2. If your PC does not support XGA/SVGA/VGA you will need to
install an XGA/SVGA/VGA graphics board. Consult your
computer's owner's manual for your XGA/SVGA/VGA configura-
tion. If you need to install a new board, see the manual that comes
with your new graphics board for installation instructions.
VGA 640
2
480 for graphics
VGA 640
2
400 for graphics
VGA 640
2
350 for graphics
VGA 720
2
400 for text
VGA 720
2
350 for text
SuperVGA 800
2
600
Macintosh at 640
2
480
Macintosh at 832
2
624
XGA1024
2
768
Macintosh at 1024
2
768
SXGA1280
2
1024 (AccuBlend)
Settings for Monitor Mode
Number of DIP switch
Monitor size
15” multi-scan mode /16”–13”
17” multi-scan mode /19”–13”
19” multi-scan mode /21”–13”
13” fixed mode /640
2
480
VGA/SVGA mode
16” fixed mode /832
2
624
19” fixed mode /1024
2
768
S1
ON
ON
ON
ON
S2
S3 S4
ON
S5
ON
ON
S6
ON
S7
ON
S8
ON
NOTE: For settings other than display modes supported by your
Macintosh and MT830/1030, use of the DIP switch may bounce a image
slightly or may display nothing. If this happens, set the DIP switch to the
13” fixed mode and then restart your Macintosh. After that, restore to a
displayable mode and then restart the Macintosh again.
Make sure that the MT830/1030 and your Macintosh are connected with
the pin adapter and the supplied signal cable (mini D-Sub 15-pin connec-
tor) and then restart your Macintosh.
3. Use the signal cable that's supplied to connect your PC or
Macintosh computer to the projector. For a Macintosh, use the
supplied pin adapter to connect to your Mac's video port.
4. Turn on the projector and the computer.
5. If the projector goes blank after a period of inactivity, it may be
caused by a screen saver installed on the computer you've
connected to the projector.
When using a Macintosh with the MT830/1030, set the DIP
switches of the supplied pin adapter according to your resolution.
After setting, restart your Macintosh.
See the following pages for setting of the DIP switches.
• When using with a Macintosh, XGA/VGA/SVGA is recom-
mended if your Macintosh supports this mode.
• When using with a Macintosh PowerBook, output may not be
set to 1024
2
768 unless “mirroring” is off on your PowerBook.
Refer to owner’s manual supplied with your Macintosh com-
puter for mirroring.
NOTE: A Video Adapter cable manufactured by Apple Computer
is needed for a PowerBook which does not have a mini D-Sub 15-
pin connector.
INSTALLATION
47
48
