Emergency Management Port Console C-5
EMP Access Modes (Server not Configured for Console Redirect)
Mode
Server is powered off
During POST
After OS boots
Disabled
Redirect window appears, but is
blank
Redirect window
appears, but is blank
Redirect window
appears, but is
blank
Pre-boot
EMP commands available
EMP commands
available
Redirect window
appears, but is
blank
Always Active
EMP commands available
EMP commands
available
EMP commands
available
EMP Requirements and Configurations
This section outlines the requirements and configurations necessary for using the EMP.
Operating Systems:
!
Windows 95
16 MB of RAM, 32 MB recommended
20 MB disk space
!
Windows NT
Windows NT 4.0 or later
24 MB of RAM, 32 MB recommended
20 MB disk space
Client Configuration:
The EMP will support all COM ports on the client system,
along with any Windows NT/95 compatible modem.
Server Configuration:
The EMP requires the server's COM 2 port to be connected to
an external modem or directly connected to a serial cable.
Direct Connect Configuration
: A null modem serial cable is needed. Connect one end
of the cable into the COM 2 port of server and the other into a port on the client
machine.
Modem Configuration
: On the client, the EMP uses the Windows Application
Program Interface (API) to determine if a modem is connected and available. The EMP
does not configure the modem; it should be preconfigured through Windows.
For modem support, the server must use a Hayes compatible 14400 bps modem. The
modem must be on the NT Hardware Compatibility List provided by Microsoft. The
server modem must be set in auto-answer mode for the EMP to be able to connect to it.
Содержание MC2400
