4-30
Upgrading Your System
If you are adding or removing a SCSI removable media device, consider the
following:
!
The optional SCSI tape drive address assignment is 2.
!
The SCSI termination resistors must be installed in the last SCSI drive of
the daisy chain cabling. If the SCSI tape drive is your only SCSI device
on the SCSI controller B, termination must be enabled in the tape drive.
Installing a 5.25-Inch Media Device
!
CAUTION
CD-ROM devices contain a laser system and are classified
as CLASS 1 LASER PRODUCTS. To use these devices,
thoroughly read the documentation provided by the CD-
ROM manufacturer, and keep the documentation for future
reference. In case of any trouble with a CD-ROM, please
contact your nearest service representative. To prevent
direct exposure to the laser beam, do not try to open the
enclosure. Use of controls or adjustments or performance of
procedures other than those specified in the CD-ROM
manufacturer's documentation may result in hazardous
radiation exposure
1.
Power off the system, unplug the system power cords, and remove the
appropriate side panel depending upon the bay you are installing the media
device in and as described earlier in this chapter.
2.
Open the front door as described earlier in this chapter.
!
CAUTION
Observe static precautions. Use an antistatic wrist strap.
3.
Carefully remove the front system bezel by releasing its two plastic snap
tabs on the back of the bezel and pulling it out (see Figure below).
Содержание MC2400
