Quick Start
How to attach IntelliBase
™
USB Hub and Audio to your
MultiSync
®
brand monitor
THE INTELLIBASE USB HUB AND AUDIO WILL ONLY WORK WITH THE
MULTISYNC BRAND MONITORS LISTED BELOW. DO NOT ATTEMPT TO
CONNECT THE INTELLIBASE WITH ANY OTHER MONITOR BRANDS.
MAKE SURE THE MONITOR IS DISCONNECTED FROM THE SYSTEM AND
IS UNPLUGGED FROM THE WALL OUTLET BEFORE ANY WORK IS DONE
ON THE MONITOR.
FOR ALL 21” MULTISYNC MONITORS
IT IS ADVISED THAT TWO PEOPLE ARE INVOLVED DURING THE ENTIRE
INSTALLATION PROCESS. ONCE THE INTELLIBASE HAS BEEN INSTALLED
ONTO YOUR 21” MONITOR, DO NOT ATTEMPT TO ADJUST THE TILT OF THE
MONITOR FROM THE BACK OF THE MONITOR UNIT. ONLY ADJUST THE TILT
FROM THE FRONT OF THE UNIT BY HOLDING ONTO THE LEFT AND RIGHT
SIDE OF THE MONITOR, TILTING EITHER UPWARDS OR DOWNWARDS. DO
NOT TILT THE MONITOR DOWNWARDS MORE THAN 5 DEGREES OR FORCE
THE MONITOR PAST THE FIRST STOP, AS THE MONITOR MAY BECOME
UNSTABLE, CAUSING POSSIBLE INJURY.
If you have any questions or comments, please contact NEC at 1-800-632-4662
To attach the IntelliBase to your MultiSync brand monitor, the original base
must first be removed. Depending on the model of your MultiSync brand
monitor, the removal procedure of the original base and the attachment of
the IntelliBase will vary. Locate the model name (located in the lower right
corner of your monitor’s bezel) of your MultiSync brand monitor in the table
below. Follow the removal procedure to detach the original base from your
monitor using the diagrams on the following pages and attach the IntelliBase
to your monitor.
2
MultiSync Monitor Model Names
Original Monitor Base
Removal and IntelliBase
Installation Instructions
MultiSync 50, MultiSync 70, XV15 and
XV15+
MultiSync XE15, XE17, XP15, XP17, XV17,
XV17+, A500, A500+, A700, A700+,
A900, E500, E700, E900, E900+, M500,
M700 and P750
MultiSync XE21, XP21, E1100, E1100+,
P1150 and P1250+
Page 3
Page 5
Page 7
203 Eng Fr Cndn manual 12/21/98 11:19 AM Page 6
