NEC HX4000, Руководство пользователя

Страница: 142 / 210

5-53
Upgrades and Options
18. Reinstall the drive bay frame, top cover, and power
on the system. It may be necessary to run the SCU as
described in the Configuring Your System chapter.
Removing a 5 1/4-Inch Device or 3 1/2-Inch Diskette Drive
1. Power off the system and remove the top cover as
described earlier in this chapter.
2. Observe the safety and ESD precautions listed at
the beginning of this chapter.
3. Remove the device bay frame, refer to Installing a
5 1/4-Inch Device or 3 1/2-Inch Diskette Drive as
described earlier in this chapter.
4. Disconnect the signal and power cables from the
back of the drive that you want to remove.
5. Remove the drive rail locking screws and slide the
drive out the front of the bay, and place it on an
antistatic surface.
6. Remove and save the side rails and locking screws.
7. Place drive in an antistatic wrapper.
8. To cover an empty bay, install a blank panel tray in
the bay.(Figure 5-26).
9. Attached the side rails and locking screws just
saved to a reusable blank panel tray previously
removed.
10. Engage the blank panel tray side rails into the bay
guide rails (see Figure 5-24). Ensure that the blank
panel tray side rails (see Figure 5-24, A) are inside
the bay guide rails (see Figure 5-24, B).