NEC Express 5800/120Ed, Руководство по установке

Страница: 11 / 29

Express5800/120Ed Rack Mount installation Procedures 9
Figure 4. Removing a Server Unit Side Panel
Installing the LED Holder and Labels
The Power and HDD LEDs must be removed from the LED holder currently
installed on the front of the chassis and then reinserted into a new LED holder.
The Status LED remains in its current LED holder and is reinserted into its
original slot in the front of the chassis. The new LED holder is then installed in
a vacant slot on the front right-hand side of the server chassis. A name plate
logo and two other labels are then adhered to the new front bezel of the server
unit.
To install the LED Holder and labels, perform the following:
1. Power off the system and ensure it is disconnected from the ac wall outlet.
2. Remove the front bezel as described earlier in this guide.
3. Remove the side panels as described earlier in this guide.
4.
Remove the LED holder currently installed on the front of the chassis by
using a pointed instrument, such as a small screwdriver or ball-point pen.
Push downward on the top tab of the LED holder while pulling the holder
away from the front of the chassis at the same time (see Figure 5).