NEC EXP320R, Руководство по установке

Страница: 63 / 88

1. Setup Procedure
Express5800/R320e-E4, R320e-M4, R320f-E4, R320f-M4 Installation Guide (VMware)
63
Chapter 1 Installing OS
Note The message does not appear when ftSys Management Appliance is configured as the log
server.
When the message below appears, enter "yes" to restart the system. The ESXi host restarts. 11.
A host reboot is required to place these updates into service.
Enter 'yes' to reboot now or 'no' to allow a manual reboot later: [yes]
After making sure that the ESXi host is shutdown, take the ft control software Install DVD out from the 12.
drive.
1.11.3 Checking status of ft server
After the ftSys Management Appliance restarts, check the duplication status. Confirm that the System 1.
FT LED on the front of the server lights.
Run the following command to confirm if the system is running normally. 2.
# /opt/ft/sbin/ft-verify
The results list for each of the configuration is output. If all items show [PASS], it indicates that the
installation has been completed successfully (Output example:).
ftSys Management Appliance hosted by xxx.xxx.xxx.xxx [PASS]
Host is configured with enough memory [PASS]
ftSys installed on host [PASS]
Host software version matches appliance (x.x.x-xxx) [PASS]
ftSys Management Appliance firewall settings [PASS]
Host Firmware Boot Type - requires Legacy BIOS [PASS]
Host Legacy memory copy BIOS setting [PASS]
ftSys Management Appliance installed on boot volume
[PASS]
Multiple paths to storage [PASS]
Network Configuration [PASS]
Host ftSys service started [PASS]
Host logs available after reboot [PASS]
DNS Configuration [PASS]
Note Record the version (x.x.x-xxx) displayed in “Host software version matches appliance”
described above. This will be used in “2.2 Confirmation of the ft control software version”.
System FT LED