1. Setup Procedure
Express5800/R320e-E4, R320e-M4, R320f-E4, R320f-M4 Installation Guide (VMware)
27
Chapter 1 Installing OS
1.7
Setting HBA configuration by using QLogic
Important Before setting the HBA configuration by using QLogic BIOS, it is required to
complete the storage settings such as creating a logical disk.
Connect power cords in the following order to start the system from CPU/IO module 0.
1.
(1) Connect a power cord to AC inlet A.
(2) Connect a power cord to AC inlet B.
Note
Wait at least 15 seconds after step (1), and then perform step (2).
If you disconnect a power cord, wait for at least 30 seconds before connecting it again.
Tips
See
Chapter 1 (1.2 Preparations for Setup)
for AC inlet connector.
Important Make sure that the PRIMARY LED on CPU/IO module 0 is lit.
Press the POWER switch that is located on the front side of the server.
2.
Note
Make sure that Module POWER LEDs on both CPU/IO modules 0 and 1 are blinking, then
press the POWER switch.
2-1
In the QLogic prompt window which appears during POST, press
Ctrl+Q
or
A
lt+
Q
to launch
QLogic Fast! UTIL.
Содержание EXP320R
Страница 87: ... MEMO ...
