Neater Powered Drinker, Инструкция по эксплуатации

Страница: 3 / 6

- 3 -
Tube clamp
Lever
Lift to open tube clamp to
load tubing.
Push down to hold tubing
against pump head before
operating pump.
Peg
Grips tubing to prevent it
being pulled through by
the pump
Output socket
For controlling
external devices
Switch socket
Suitable for standard
switches with 3.5mm jack
plug
Power/battery charge socket
Only use the 12V DC power supply supplied with the unit.
The display flashes
“ c ” when charging i s required.
Charging overnight is recommended though the unit can be used whilst charging.
A
red LED glows inside when external power is plugged in.
A green LED glows inside when the batteries are charging and goes out when fully charged.
If the green LED flashes, a reset is required (battery protection from over-discharge):
Ensure the Battery Switch is On. Then use a pin through the small hole next to the display to
briefly press the reset button. Contact your Neater dealer if a new battery pack is required.
Display shows
programme number,
pump cycle symbols,
priming symbols
C = please charge battery
DISPLAY GOES OUT AFTER A
WHILE TO SAVE BATTERY POWER.
To wake up the unit, tap the plug-
in switch or switch off and on
battery or external power.
Black programming buttons
To change programme:
(ensure display is lit)
1.
Push and hold top button
until
“ - “ appears
2. Select number
(higher=longer pumping
time) with middle button
3. Push top button to confirm
choice
Red pump-priming button
To fill tubing with liquid at
start:
(ensure display is lit)
1.
Push and hold until
flashing “P”
2. Let go of the button
briefly
3. Push again and hold to
prime pump until liquid is
near the top of the tube.
You can let go and push again
as long as “P” is still flashing
(it will time-out after a few
seconds)
Adjusting screws
(factory set to suit
precision tubing)
Pump head
Display millilitres
approx
1 2
2 3
3 4
4 6
5 8
6 11
Battery On/Off
Switch off when not in
use to save battery. (Still
works on external power.)
.