NDS ExpandOR, Руководство по установке

Страница: 41 / 52

33

I can’t get Transmit to work. How can I identify the issue?

Verify that the input source is properly connected, turned on.

When transmitting or receiving, local S-Video out shows the transmitting stream. When only
transmitting is active, local DVI out also displays the transmitted video stream.

If the local displays shows the transmitting stream correctly, then the issue is with the receiving end or
the transmit parameter configuration.

When the Web interface shows “Polling” it indicates the input source is either not correctly connected
or its resolution not supported.

When connecting a source, make sure you are using digital DVI. Analog DVI and VGA are not
supported even though they use the same connector.

What's the relationship between video bitrate / bandwidth vs. quality
A default value of 8 Mbps provides good quality without using too much bandwidth. When recording a
video at 8 Mbps, the file size is ~3.5 GB/hour. As you decrease the bitrate, the data sent on the network
(and the file size) decreases, and the quality is reduced accordingly – the table below shows the per hour
file sizes for each available bitrate setting:

What is the resolution of a captured still from a recorded video stream?
The captured still file is stored at the resolution of the stream being sent or received - the compression rate
is fixed, and the file size depends on the stream resolution and image being processed.

Can I connect VGA output to ExpandOR’s DVI-IN port?
VGA signals and analog DVI signals are not supported. All inputs must be digital DVI.

I changed the name of my ExpandOR - why doesn’t the CruzOR show the old name of the ExpandOR?
This is a known limitation that will be fixed in a future version.

When I record the incoming stream, no audio is recorded.
This is a known limitation that will be fixed in a future version.

I can’t get the Receive function to work.
Check the following:

Verify the port you are configured to receive on is the same port as the transmitter is sending on.

Verify the DVI output is connected to a display that supports the configured output.

Verify the transmitting device is on the same network as the receiving device.

Does the ExpandOR support encryption?
Encryption is currently not supported.
600k = 0.25 GB/hour 10M = 4.4 GB/hour
1M = 0.45 GB/hour 15M = 6.6 GB/hour
3M = 1.3 GB/hour 20M = 8.8 GB/hour
6M = 2.6 GB/hour 25M = 11 GB/hour
8M = 3.5 GB/hour 30M = 13.2 GB/hour