NDS EndoVue 19", Руководство пользователя

Страница: 13 / 32

VESA Compliant Display Mounting | 1
VESA Compliant Display Mounting
EndoVue series displays are compliant with the VESA Mounting Interface Standard, with MIS hole mount
patterns configured to size and weight of the display, suitable for stand, wall, or armature mounting. MIS-D 100 x
100 mm and MIS-E 200 x 100 mm interfaces are shown below.
Monitor Stand Installation
To install the EndoVue monitor stand (optional for 19", 21", and 24" monitors), place the monitor screen-down on
a clean, flat surface and position the four mounting screw holes of the stand mounting bracket over the four-
hole attachment interface on the monitor back.
Insert one of the four provided cap screws into a screw hole and lightly tighten. Repeat the process with the
remaining screws, and then check to confirm that the mounting bracket is flat against the back surface of the
monitor before tightening all screws securely.
Note: Mounting bracket of the stand can be tilted up to 30°.
Warning: The mounting bracket screws must be securely tightened. Failure to properly secure the
mounting bracket to the display could be hazardous. Use suitable mounting apparatus to avoid risk of
injury.
100 mm
200 mm
100 mm
M4 X 0.7
Thread
(4x)
M4 X 0.7
Thread
(4x)
Mounting
Bracket
M4 Cap Screw
(4x)