NDS DOMETIC BS 115WP, Инструкция по установке и эксплуатации

Страница: 15 / 340

EN
Mounting the solar panel
WARNING! Risk of injury
Use a suitable adhesive, e.g. Sikaflex ® -554. Do not use silicone.
NOTICE! Damage hazard
Before drilling any holes, ensure that no electrical cables or other parts of the vehicle can be damaged by
drilling, sawing or filing.
1.
Apply adhesive to the side roof mounting supports of the solar panel ( 1 , fig.

).
2. Place the solar panel on the prepared bonding surface on the vehicle (
2 , fig.

).
fig.

on page 2
3.
NOTICE! Damage hazard
• Do not press too hard on the surface of the solar panel.
• Do not press on the center of the solar panel.
Press the side roof mounting supports lightly against the adhesive surface.
4. Drill a hole into the vehicle surface for the connection cable.
fig.

on page 2
5. Route the connection cable from the junction box through the cable gland (
1 , fig.

).
6. Route the connection cable from the cable gland through the roof duct (
2 , fig.  ).
7. Route the connection cable through the pre-drilled hole into the vehicle interior (
3 , fig.

).
8. Fasten the cable gland onto the roof duct (
4 , fig.

).
fig.

on page 3
9. Apply adhesive to the back of the roof duct.
fig.  on page 3
10. Place the roof duct on the prepared bonding surface on the vehicle.
Note Mount the roof duct in the direction of travel of the vehicle to avoid wind and rain loading on
the cable gland.
fig.  on page 4
11. Fix the roof duct, e.g. with adhesive tape, until the adhesive has dried completely (after approx. 12 h) to ensure
that the roof duct rests firmly on the surface of the vehicle.
Note Wait at least 48 h before moving the vehicle.
fig.

on page 4
Connecting the solar charge controller (accessories)
Observe the following instructions when connecting the solar charge controller:
13