7. Turn on the System
WorldMark 4380 Deskside Hardware Installation Guide
9
7. Turn on the System
If your server has the optional battery support system, switch the local battery disconnect switch
on the back of the server to the “On” position before turning on the server. Refer to the figure in
the “Connect Peripherals” section for the location of the battery disconnect switch.
To turn on the server:
1. Turn on the monitor.
2. Turn on the system by pressing the power on/off switch (green push-button switch located next
to the 3.5-inch diskette drive).
3. Verify that the power LED (left-most light) on the front panel is lit.
4. Watch the monitor screen as the system boots up. After a few seconds, POST (Power-On Self-
Test) starts running. Wait until the following message displays:
Press <D> to boot Diagnostic Partition
Press <F1> for normal boot, <F2> for BIOS Setup
Otherwise, <F1> is selected in 30 seconds
PRESS “D” IMMEDIATELY.
