NCR RealPOS 80c, Руководство пользователя

Страница: 82 / 165

3-2 Chapter 3: Setup
Restoring Factory Settings
To reset all values to their default settings for the current screen , press
F9. The terminal automatically loads the BIOS default values.
To reset
all BIOS settings to their default settings go to the Exit menu,
press F9, select either Save Changes & Exit or Save Changes , and press
[Enter] .
See the BIOS Default Settings section later in this chapter for the pre-
installed Setup defaults.
Special DynaKey Keypad Mode
If your Terminal is configured with a DynaKey or Touch Screen
module refer to the following sections that discuss special keypad
considerations. Otherwise, proceed to the
Configuration Setup
Procedures section.
Many of the Terminal setup routines require keys that are not present
in the regular DynaKey keypad layout (such as the ESC and .0END
keys). Although the DynaKey has a PC keyboard connector, a PC
keyboard may not be readily available to the operator.
Note:
No setup is required for the DynaKey module itself at
installation unless the factory default configuration needs changing.
The operational parameters can be changed using the
Wedge
Configuration Utility (G370-0701-0000) diskette or the 7452 Diagnostics
and BIOS Images (497-0406703) diskette.
To use the DynaKey without a PC keyboard attached to run the
Terminal setup routines, you must place it in the Special DynaKey
Keypad Mode. This mode replaces the normal keypad layout and
function keys with special key assignments that are required to run
setup. To enter the special mode, press the
7 and 9 keys simultaneously
during POST diagnostics.
Note: The 7 and 9 keys must be the FIRST keys pressed during/after a
power up, otherwise the keypad enters the normal layout.