NCR 7360-K502, Инструкции к набору

Страница: 7 / 38

7 Input Belt Adapter
Installing the Input Belt assembly
To install the Input Belt assembly to the SelfServ Checkout unit with the Input Belt
Adapter, follow these steps:
Note: This procedure shows images of a Right-Hand unit for illustration purposes only.
The steps are the same for a Left-Hand unit.
1. Do the following:
a. Remove the Conveyor Belt from the Input Belt assembly. For more information,
refer to Removing the Conveyor Belt assembly on page 30.
b. Remove the Input Belt assembly from either the NCR SelfServ™ Checkout (7350)
or NCR FastLane SelfServ™ Checkout (7358) R6L Plus. For more information,
refer to
Removing the Input Belt assembly on page 34.
2. Insert three (3) screws into the lower U-Channel Input Belt Adapter as an alignment
guide. Leave at least ¼ inch of the screw threads visible.