NComputing N-series User Manual rev11.09.12
Page
5
of
25
GPL Declarations
The NComputing N-series access device contains – in part – some free software (software licensed in a
way that ensures your freedom to run, copy, distribute, study, change and improve the software). This
free software is also contained in the N-series firmware update files that are distributed online. The free
software contained within the N-series firmware includes a version of X-LOADER, U-BOOT, LINUX,
LIBSYSFS, LIBUCI, LIBUSBIP, ETHTOOL, UCLIBC, QT and BUSYBOX.
Further, for at least three (3) years from the date of distribution of the applicable product or software,
we will give to anyone who contacts us at
, for a charge of no more
than our cost of physically performing source code distribution, a machine-readable copy of the
complete corresponding source code for the version of the software that we distributed to you. For
additional information refer to this page on the NComputing website:
www.ncomputing.com/gplcodedownload
Safety Information
Refer to the following to prevent any physical injury or loss of assets caused by damage to the product.
A user must read this User Manual carefully before use and properly follow the instructions.
Make sure that the place of installation is not too hot (above 35˚C), too cold (below 0˚C), or too
wet (above 85% relative humidity).
Avoid any severe impacts to the product
Make sure that the product is not exposed to direct sunlight or any hot machinery.
Please keep the product away from any items which have strong magnetic properties.
Do not disassemble, repair or rebuild the product.
Please properly route all cables and power cords to avoid a tripping hazard. An electric shock,
fire, damage to the product or physical injury may occur as a result of tripping over the cable.
