NComputing L-Series User Manual rev.05.07.12
Page
6
of
95
Safety Information
Refer to the following to prevent any physical injury or loss of assets caused by damage to the product.
A user must read this User Manual carefully before use and properly follow the instructions.
•
Make sure that the place of installation is not too hot (above 35˚C), too cold (below 0˚C), or too
wet (above 85% relative humidity).
•
Avoid any severe impacts to the product
•
Make sure that the product is not exposed to direct sunlight or any hot machinery.
•
Please keep the product away from any items which have strong magnetic properties.
•
Do not disassemble, repair or rebuild the product.
•
Please properly route all cables and power cords to avoid a tripping hazard. An electric shock,
fire, damage to the product or physical injury may occur as a result of tripping over the cable.
Regulatory Compliance
FCC Information
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant
to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try and correct the interference by one
or the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and the receiver
•
Connect the equipment to a power outlet on a circuit different from which the receiver is
connected
•
Consult your dealer or an experienced radio TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
For enhancing performance and reliability, we recommend using an FTP or STP cable between the L300
and the client devices.
