17
Safety Information
FOR SAFETY & PROTECTION READ THE FOLLOWING
Both operators and maintenance personnel must read the following safety
notice. The information below is given for your own safety. They must be
read before operating or carrying out any maintenance to the machine.
Local site rules must be adhered to at all times.
•
Before operating the machine ensure that correct training has been given, and you are fully
conversant with the machine and its controls.
•
A full training regime must be put in place for all operators to insure safe use of the machine.
•
Do not operate the machine unless trained.
•
All personnel must read these instructions before operating the machine. Always ensure instruction
manual is kept with the machine. If it gets lost, damaged or dirty replace it immediately.
•
The decals are fitted to the machine for safety, if any become unreadable replace them with new
equivalents.
•
Always ensure that the machine is run in a well ventilated area. Never run engine in a confined
space or close to flammable material.
•
While refuelling the machine ensure that the engine is stopped. If fuel is split whilst refuelling take
measures to clean it up, do not restart engine until it is safe.
•
The exhaust of this machine can reach high temperatures do not place objects close to it or on it.
Do not perform maintenance on a hot engine.
•
Operator must be aware of all prohibited areas e.g. slopes, rough or dangerous terrain.
•
Do not clean around the machine if the engine is running.
•
When carrying out maintenance on the hydraulic system ensure that the oil is cool and that there is
no residual pressure in the circuit. Skin could be penetrated from hydraulic oil under pressure.
•
Ensure that the operator wears all the necessary safety equipment at all times.
•
Do not operate the machine if it is damaged, incorrectly adjusted or unassembled.
•
To prevent an accident, place a warning sign on the machine and remove keys whilst performing
maintenance.
•
When filling the skip no persons should be on the machine.
•
Do not carry passengers.
•
The foot plate should be kept clean from oil or dirt.
•
Do not remove the coolant cap when engine is hot. Do not add coolant to the engine when hot.
•
The machine should be parked in a safe position on firm level ground. Never leave the engine
running or key in the ignition.
•
Before taking the machine onto the public road insure that the vehicle adheres to all road traffic
regulations. When on the road driving laws must be obeyed.
•
Tyre repair must only be carried out by trained persons with the correct knowledge and equipment.
A reputable tyre firm with competent staff is recommended for this task.
•
If the machine does roll over, the driver should brace themselves, hold tight to the steering wheel,
allow the seat belt to retain them and wait for the machine to come to a halt.
•
If replacing parts always use parts supplied or recommended by the manufacturer. Never use parts
of lower specification.
•
Always use qualified personnel to carry out repairs on the machine.
•
Never over fill the engine with oil or the fuel tank with fuel.
•
If the hydraulic oil level is low never start the engine.
•
When starting the machine follow the instructions on the manual and on the machine.
•
If oil is leaking from the machine report it and get it repaired immediately.
