Naxa NRC-180, Инструкция по эксплуатации

Страница: 8 / 16

Page 8 Naxa Electronics
Connecting the Unit to
Power
Plug one end of the power adapter into the Power In-
put jack, and then plug the other end into AC wall out-
let. Before switching on the unit, make sure that the
voltage of your electricity supply is the same as that
indicated on the rating label of the power adapter.
ѥ
ѥ
The included adapter accepts AC
100-240V power.
Battery Backup
Battery backup will preserve the current time,
alarm settings, and stored radio stations in the
case of power failure or interrupted AC power.
Insert two UM-4 batteries (AAA) into the battery
compartment. Be sure to observe the proper po-
larity (the “+” and “-” signs) as indicated inside the
battery compartment.
Setting the Clock
While the system is in Standby mode (i.e., the radio
is off):
1. Press and hold the PRESET/TIME SET button.
The time will begin to flash on the display.
2. Press the button to adjust the hour; press
the button to adjust the minutes.
• Hours and minutes run forward only
when being set; if you pass the desired
time, continue pressing the button until
the time cycles back around.
3. When the correct time is set, press the
PRESET/
TIME SET
button again to confirm.
ѥ L
Take note of the PM LED indicator
when setting the clock.