1.3 Maintenance and Cleaning of Discs
Disc Maintenance
1. To
h
1.
Do not use petrel, thinner. commercially cleaner or anti-static spray can
damage the unit.
keep the disc clean, andle the disc by its edge, do not touch the disc
surface of the play side.
2. Do not stick paper or tape on the disc. If there is glue (or analog) on the
disc surface, must wipe it up before using.
3. Do not expose the disc to direct sunlight, or nearby heat sources such as
caliduct, or leave it in a car parked in direct sunlight where there can be a
considerable rise in temperature.
4. Put the disc inside disc case to keep temperature after finishing playback.
Before playing, wipe the disc with a clean lint. wipe the disc outwards from
the disc center.
2.
Disc Cleaning
Fig.1
Fig.2
Fig.3
A
B
+ side up
1.4 Battery Information of the Remote Control
Replace Battery in the Remote Control
Note about the Battery of the Remote Control
:
1.Before using the remote control for the first time, pull the insulating
sheet out of the remote control as the direction indicated by the
arrow.(see fig.1)
2.Press the movable block hold as the direction indicated by the A arrow
(See fig.2), then pull the battery holder out of the remote control as
the direction indicated by the B arrow(see fig.2).
3.Replace the old battery by a new battery with (+) polarity side upward.
(See fig.3).
4.Insert the battery holder to the original position in remote control.
(See fig.3).
:
1.Lithium battery: CR 2025 3V.
2.Battery Life: 6 months with normal use in normal room temperature.
3.Improper use of battery may cause overheating or explosion, so that
Result in injury or fire .
4.Battery leakage may cause damage to the remote control.
5.Do not short the battery.
6.Do not throw the battery into the fire.
7.To avoid the risk of accident, keep the battery out of reach of children.
7. Specification
General Specification
Power Supply Requirement..................................................DC 12V
Dimensions(w x h x d)...........................................178 x 50 x 160mm
DVD Deck Specification
Format.....................................DVD/VCD/JPEG/MP4/MP3/WMA/CD
Video System....................NTSC/PAL/PAL-M/PAL-N/AUTO(optional)
Audio System..............................................................24 bit/96KHz
Loading System.......................................................... Auto Loading
Mounting Angle.................................................................0 to +/-30
Video
Video Type...................................................................16:9 and 4:3
Video Output level......................................Composite:1.0
0.2Vp-p
Load impedance: 75 ohms
Horizontal Resolution................................................................500
Audio
Audio Output(Analog audio)..........................................2.0
Vrms
Frequency Response.............................20Hz ~ 20KHz(at 1KHz 0 dB)
S/N Ratio(Audio).............................................
90dB
Separation..............................................................................50dB
Radio
FM Section
Frequency range..............................................87.5MHz - 107.9MHz
Usable sensitivity......................................................................3uV
I.F Frequency....................................................................10.7MHz
AM Section
Frequency..........................................................530KHz - 1710KHz
Maximum Power Output.............25W x 4 (measured at DC 14.4 V)
Specification
Specification
(at 1KHz 0 dB)
Specification
±
≥
+0
-1.0
PDF created with FinePrint pdfFactory trial version
http://www.pdffactory.com
