NAX 3001S, Руководство пользователя

Страница: 48 / 144

48 EN
TROUBLESHOOTING
Problem Possible cause Solution
The device
does not start
Low fuel. Check the fuel level and add fuel if necessary.
Spark plug flooded or damaged. Check, clean or replace the spark plug.
Interruption in ignition system
or contaminated fuel insert.
Have the gardening equipment service repaired, it is best
to entrust the mower to an authorized service center.
Engine fires
unevenly
Contaminated air filter. Replace or clean the filter.
Low quality fuel. Remove fuel and refuel the mower with high-quality fuel.
Clogged fuel line, no fuel or old fuel. Clean the fuel line, check fuel delivery, add fresh fuel.
Water, oil or dirt in the fuel system.
Drain the carburettor with the fuel sink screw and top up
with fresh mixture.
Oil flooded carburettor after tilting the
mower to the side.
Clean the carburettor from oil.
The engine
goes out
Badly adjusted brake cable. Make the appropriate adjustment.
Dirty air filter. Replace the filter.
The engine is
smoking
Muffler flooded with oil after tilting the
mower to the side.
Top up oil and start the mower for 15 minutes, the oil will
burn itself.
Excessive
vibration
Knife adapter damaged. Replace it.
Crooked motor shaft (after impact).
Stop the engine immediately and remove the spark plug
cap. Tighten all screws and make other appropriate
repairs. If the vibration does not disappear, entrust the
repair to an authorized service center.
Loose assembly of components.
The mower
does not
throw grass in
the bin
The grass is too high. Mow twice.
Wet grass. Do not mow.
Inverted or worn cutting knife. Insert the cutting knife correctly or replace it.
Dirty lawn mower chassis. Clean the mower chassis.
A dirty or overfilled basket. Empty and clean the basket.
Engine speed too low. Adjust the turnover at the authorized service center.
Wheel drive
not working
(drive
version)
Worn or damaged drive belt. Replace the wheel drive belt.
Cut grass lying down. Clean the transmission mechanism.
Incorrectly adjusted drive cable. Adjust the drive cable.
Worn drive protection mechanism. Replace the gear.
WARRANTY AND SERVICE
The product purchased by you is intended for amateur (hobby) use only. If the equipment is used for other purposes
(commercial, professional), it will lose the guarantor's liability for the purchased equipment. You can find information on the
warranty and the NAC service network in the attached warranty card.
Remember that the machine should be cleaned after each use. Keeping the equipment clean will ensure long-term and
reliable operation. Cleaning, maintenance and periodic inspections are not repairs. Authorized NAC services may perform
these activities as part of a paid service.