NAX 3001S, Руководство пользователя

Страница: 46 / 144

46 EN
1. turn the adjusting nut 2 (Rys.(Fig.) 22) counterclockwise: the cable is shortened,
2. turn the adjusting nut 2 (Rys.(Fig.) 22) clockwise: the cord will be extended.
GREASING
The swivel wheel bearings should be lubricated by introducing a small amount of aerosol lubricant directly onto the bearing
25 (Rys.(Fig.) 23).
To lubricate the rear drive wheel rack 8 (Rys.(Fig.) 1) you should:
1. Remove the rear wheel hub cap by turning the hub cap counterclockwise.
2. Unscrew the drive wheel nut with a 13 mm wrench.
3. Remove the drive wheel from the axle.
4. Remove the Seger ring 26 (Rys.(Fig.) 24) and then slide the drive rack off 27 (Rys.(Fig.) 24), from the gear shaft
29 (Rys.(Fig.) 25) .
5. Sprocket, drive carrier 28 (Rys.(Fig.) 25) and the gear shaft must be cleaned of grease residues and lightly grease the above
elements. The recommended grease for this operation is NAX bevel gear grease.
CAUTION! Lubricate the gear wheel from the inside 27 (Rys.(Fig.) 25). Do not lubricate the outer rim on the sprocket
and the drive wheel.
6. Refit the entire mower drive mechanism in reverse order.
TRANSPORTATION
PREPARATION FOR TRANSPORT

Before transporting the mower, remove oil, then: cool the engine, remove fuel from the tank, carburettor and fuel lines.

The device can only be transported in the working position, i.e. at an angle of up to 15 degrees above the level.

The handle may be folded.
Attention! Be careful when folding or unfolding the handle, as the cables may be damaged. Damaged cables can cause the
mower to malfunction and in some cases reduce the safety of use of the device.