Version 02.12.2022
HW:CAM(V100)/(V33)
RL4-MIB
P
a
g
e
5
Limitations
Video only
The interface inserts ONLY video signals into the infotainment. For inserting
Audio signals either the possibly existing factory audio-AUX-input or a FM-
modulator can be used. If 2 audio sources shall be connected to the infotainment,
an additional electronic is necessary to switch them.
Factory rear-view camera
Automatically switching-back from inserted video to factory rear-view camera is
only possible while the reverse gear is engaged. To delay the switch-back an
additional electronic part is required.
After market front camera
The front camera will automatically be switched for 10, 15 or 20 seconds
(adjustable) after disengaging the reverse gear. A manually front camera
switching is possible by external keypad.
PDC and guidelines
If the video interface does not receive the required information from the vehicle
CAN-bus, neither guide-lines nor optical PDC display will be supported.
Place of installation –
On some vehicles, e.g. VW Polo, there may not be enough space behind the
special case
factory head unit for the straight female HSD interface connector of the interface
cable. In this case, the optional cable CAB-HSD-MD035 is also required.
1.3.
Connectors – video interface
The video-interface converts the connected after-market sources video signals into a LVDS signal
which is inserted in the factory monitor using separate trigger options. Further it reads the
vehicle’s digital signals out of the vehicle’s CAN-bus and converts them for the video interface.
