SECTION 5 – MAINTENANCE SCHEDULE AND SERVICE PROCEDURES
Service Procedures (cont.)
FUEL STRAINER (cont.)
10. Depress clutch pedal if equipped.
11. Turn ignition switch to ON for approximately 60 seconds
allowing fuel pump to prime the fuel system.
12. Start the engine and check for leaks.
See Starting the
Engine (page 48).
13. Check for leaks. If leaks are found, shutdown the engine
and correct the problem.
14. Once leaks are fixed or no leaks are found, shutdown the
engine.
ELECTRICAL SYSTEM
Service Interval: Annually
1.
Check wiring harness for cracks, rubbing, and loose
connections.
2.
Check sensors for loose connections, corrosion or cracks.
3.
Check battery cables for the following conditions:
•
Broken insulation.
•
Rubbing or chaffing.
•
Corroded or loose connections.
4.
Repair items identified.
Electronics
Check for diagnostic fault codes and repair as required. After
repairs are made, clear fault codes and verify they do not
reappear.
For correct procedures, see the MaxxForce® DT,
9, and 10
Engine Diagnostic Manual
or contact an authorized
service provider.
Form No. 1172040R1
Page 86
Printed in the United States of America
Содержание MaxxForce DT 9
