NAVIS NavDP 4000 Series, Руководство по эксплуатации

Страница: 68 / 348

NAVIS NavDP 4000. Operation Manual
POS panel — to select a position control mode. See Section 9.3, page 165 for details.
FUN panel — to select a function. See Section 10, page 171 for details.
TAL
panel — to select a TAL mode. See Section 6.3, page 115 for details.
SYS panel — to select window, confirm selected mode/function, acknowledge alarms and silence.
5.2 DP Windows (Views)
Each of the Operator Selected Page is used for displaying one of information windows; each of them is used for
parameters setting and serves a particular purpose. Press the Select window softkey, and the Select Window appears on
the screen (see figure 5.8).
This window contains sofkeys to be pressed if a particular window must be displayed.
The Window List below shows the purpose of each window.
Softkey Window Comment
Alarm Alarm Window section 4, page 57
PARAM Parameter Window section 5.9, page 85
Map Position and Heading Display section 5.4, page 70
AUTO THR Auto Thruster Window section 6, page 101
MAN THR Manual Thruster Window section 6, page 101
Power Power Monitoring Window section 6.4.4, page 119
Sensors Sensor Window section 7, page 126
REF Reference System Window section 8, page 139
Target Target Window section 10.5, page 180
Track Track Window section 10.6.3, page 190
CAP Analysis Capability Analysis Window,
Drift Analysis Window section 10.8, page 207,
section 10.9, page 218
CONS Analysis Consequence Analysis Window section 10.10, page 227
Help Help Window section 5.3, page 69
Trend View Trend View Window section 5.8, page 81
System Monitor System Monitor Window section 10.12, page 232
AP Autopilot Window section 10.7, page 201
The window content depends on the configuration and options of a system.
The screen always contains two different information windows.
Softkeys with the open windows’ titles are white highlighted.
5.2.1 Quick Switcher Panel
Some of information windows are available from the Quick Switcher panel (see Figure 5.10):
– Alarm;
– Map;
– AUTO THR;
– Power;
– Help.
Hold your touch at the top of the screen in area of either status line or alarm/message line until the Quick Switcher
panel will appear (see Figure 5.9).
The Quick Switcher panel contains sofkeys to be pressed if a particular window must be displayed. The panel content
depends on the configuration and options of a system.
Softkey with the open window’s title is white highlighted.
67
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”